Powervamp Coolspool 130

Powervamp’s 26 volt DC Coolspool ramp carts are designed to replace diesel GPUs or fixed and semi-mobile transformer rectifier units (TRUs). Where no mains power is present or noise curfews prohibit use of diesel GPUs, they are a highly efficient, low cost power source – operating at a fraction of the cost of a diesel GPU, yet able to deliver the same power and turbine starting output. These large, new generation, powerful, heavy-duty battery carts provide a combination of instant high amperage with pure DC wave form and full mobility, low initial investment and extremely low operating costs. Their zero noise and zero carbon footprint are the way forward for regional airlines. Direct cost comparisons between diesel and Coolspool show savings enabling some operators to amortise the Coolspool GPU in less than 6 months.

• Peak amps (max starting current): 2000 amps
• Max. power supply output: 80
• Continuous rating (recommended): 60
• AC input voltage @ 220V: 8 amps
• Length: 1060mm (42in)
• Height: 720mm (281in)
• Width: 710mm (28in)
• Weight: 157kg (346lbs)
• Batteries 26V:
• Control panel: Digital voltmeter, digital ammeter, On/Off power knob
• Charge input plug: CS130, CS260: Single phase
• ON/OFF emergency isolator: Heavy-duty double pole push/pull switch with red mushroom knob
• Accessory socket: 26V DC accessory socket, fused @ 10 amps, suitable for worklight, DC
• Power cells: 5 x 130 amp/hr series connected starved electrolyte gas recombining cells. Cells cleared for air transportation. Correctly protected in accordance with ICAO regulations
• Tyres: 4 x 260mm (10.5in) pneumatic
• Integral power supply charging: 110/220V AC selectable single-phase switch mode powersupply/charger. Regulated to 31.2 volts DC. Units comprise 2 x 20 amp TEFC independent switch-mode modules paralleled for reliability. Short circuit protected, current overload protection
• NCAGE: KD628